Setup

[Grudge]

Ok i know i am asking alot here but im going to give it a whirl anyways to try to make the Show EQ setup experience as painless as possible.

Ok i have 3 cpus all networked together through a cable modem/hub etc etc. When i install Linux and show eq do i need to tell it to only sniff one of the computers packets or.... As you can see im totally clueless at this time. We have not installed show eq yet because we are unsure we can use it on a small network.



ANY and i mean ANY help would be much appreciated. Maybe someone can throw me a direct link on where i can go to get a guide to set EVERYTHING up. =:-)

THanks

[high_jeeves]

There are MANY guides on this site... my first recommendation is that you SEARCH for the guides... If you come here posting a question like "How do I install ShowEQ" before you look for the guides you will get flamed to no end...

This is your only warning..

-Jeeves

[Dedpoet]

There is a huge thread a couple of posts below yours called "Unofficial ShowEQ setup and HOWTO." That should help you out.