udpecho

[winseq]

I'm noticing that there may be some confusion over how to use udpecho due to changes made between v0.1 and v0.2.

v0.2 does not use the adapter's name. Instead it uses the index number provided when you list the adapters.

For example, when I type 'udpecho' all by itself in a dos window, my system says:

udpecho v0.2
non-Unicode system (95, 98, ME) detected
Usage: udpecho <IN> <OUT>
<IN> should be the index number (below) of your dial-up adapter
<OUT> should be the index number (below) of your LAN adapter
NICs available:
0 - PPPMAC
1 - DC21x4

Then I would type 'udpecho 0 1' to have the packets echoed from adapter 0 (my dial-up adapter) to adapter 1 (the NIC connected to my lan).