Man oh man

[Always Curious]

SEQ will not Decode correctly:

Run Sniffer on EQ box. Shared out directory to ~ux box via Samba. Made sure that keyfile.dat is linked to where it is supposed to be.

In SEQ I go to Decode and make sure that keyfile.dat is the file I am loading the key from.

Start Sniffer -> EQ -> SEQ....in that order

GPS and Maps come up fine

Once in EQ I zone and wait for beep. Once beep is heard I Goto SEQ and select menu Decode -> Load Key

~~~~~~~~~~~~~~~~~~~~~~~~~~
This is were everything breaks

Map goes beserk and gets really small....Path lines start to appear but nothing gets decoded.

I zone over again and SEQ completely shuts down.

I have the latest version from CVS and I am running ~ux 7.1 if that matters.

I am sure this is operator error. Requesting help if I may.

Thanks,
Always

[MisterSpock]

Do you have the latest libEQ.a and is SEQ using it when you build it?

[Always Curious]

I think So Mr. Spock,

I have the libEQ.a file that matched up to SEQ 2 versions ago before the Decode option was added to the drop down menus. I did not see where a newer version had been released with the last 2 SEQ updates. If there is a newer version of libEQ.a, I would be sure to D/L it asap and recompile :)

I am trying to reach the sites now where that file resides but I am unable to get through to check.

Thanks for your help
Curious

[Always Curious]

All Fixed....Thanks for your reply mister spock.